How to use the program:
Output image settings
Set in Width of output image or Height of output image necessary size of output image. Values are in centimetres. Width and Height values change in proportion. Set in Print resolution, dpi necessary resolution of output image.
Alignment marks - turns off and turns on the alignment mark. Click Marks size... to open dialogue Alignment marks settings. Here you can change the sizes of alignment marks and type of marks:
Check-on Show marks of the mechanical pitch to add the mechanical pitch (Read about mechanical pitch here):
Special coloured spots are used for exact alignment the lenticular sheet and interlaced print. Look at the center of the picture and move the lenticular sheet to get the symmetrical coloured spots:
Click Layout... to open this dialogue:
Here you can set the number of images by vertical and horizontal. You can print several images on the same sheet simultaneously and then cut them. Remember, Width of output image and Height of output image are sizes of single image. Also you can split the big image to several parts to make a big built-up poster.
Tiff Options defines the TIFF compression:
In the drop-down list
Flip/3D algorithm makes a simple interlacing. 3D algorithm changes a intensity inside a strip. Edges of strip is more pale, middle of strip is more bright. It reduces the ghost images: